State on UNIX systems ~~~~~~~~~~~~~~~~~~~~~ Source releases starting from 1.1.2 should compile and run out-of-the-box on old UNIX systems, such as IRIX. Does NOT require any GNU installed. Requirements: - x11 and motif (for the GUI) - an awk implementation that supports gsub(), e.g. nawk 1. ./configure 2. make Considerations listed in ../INSTALL apply. The above procedure has been tested on IRIX 5.3 on IP22. Expected compilation times [minute:second]: pcb-rnd ./configure compile, -O0 compile -O3 system ----------------------------------------------------------------------------------- 1.1.2 1:55 7:40 14:27 IRIX 5.3, IP22 @ 100 MHz 2.3.1 0:20 1:47 7:52 AIX 7, Power7 3.0.0 3:25 28:20 IRIX 5.3, IP22 @ 100 MHz (no GUI) 3. per UNIX system notes 3.1. AIX It is possible to compile pcb-rnd using gtk2.0 but due to a non-standard AIX libc header, this needs extra CFLAGS for configure: ./configure CFLAGS=-D_LINUX_SOURCE_COMPAT Without that, gtk is not detected becaus of name clash between gtk and AIX libc on func_data.