pcb-rnd - the [cycdrag] patches, negative box select
When a selection is made using drag&drop (box selection), depending
on the direction the rule for object selection differ:
- drag from top-right towards bottom-left (positive sized box):
select objects that are fully contained in the box (original behaviour)
- drag from bottom-left towards top-right (negative sized box):
select objects that are even partially within the box or merely touch
the edge of the box
save/load and compatibility
Not affected.
plans
Work more on some rough corners of the negative direction: e.g. pads are
handled as 0 width lines so the selection has to hit the center.
