ID: | 871 |
From: | ge...@igor2.repo.hu |
Date: | Mon, 11 Sep 2017 09:12:41 +0200 (CEST) |
Subject: | Re: [pcb-rnd] bugreport - impossible selection of off grid trace |
in-reply-to: | 870 from Evan Foss <ev...@gmail.com> |
On Sun, 10 Sep 2017, Evan Foss wrote: >> The reason you can select by endpoint is probably because you have snap to >> off-grid points of line on and it simply snaps at the endpoint even if it is >> between grid points. > > Ok but how did the line end up there in the first place? I was using > the rubber band mode that rubber band keeps middle line dir. I think the rubber band doesn't respect the grid. It should. Ade, could you please take a look? The minimal example Evan sent earlier in this thread demonstrates it perfectly: grab the horizontal line, move it up/down. Expected: the line snaps to grid points; what we get instead: the move ignores the grid and the line ends up between grid points. Regards, Igor2
Reply subtree:
871 Re: [pcb-rnd] bugreport - impossible selection of off grid trace from ge...@igor2.repo.hu